I think the final pass will have to be with a much smaller endmill, so I get sharper corners, and then a file with a sharp corner.
Conservative. Idaho. Software engineer. Historian. Trying to prevent Idiocracy from becoming a documentary.
Email complaints/requests about copyright infringement to clayton @ claytoncramer.com. Reminder: the last copyright troll that bothered me went bankrupt.
Wednesday, October 5, 2016
Usually, I Prototype in Acetal If I Plan to Make it in Aluminum
I didn't have a big enough piece of acetal, so I prototyped in pine. Watch it go over the knot, and you will see why airplane skins aren't carved from pine.
I think the final pass will have to be with a much smaller endmill, so I get sharper corners, and then a file with a sharp corner.
I think the final pass will have to be with a much smaller endmill, so I get sharper corners, and then a file with a sharp corner.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment