Conservative. Idaho. Software engineer. Historian. Trying to prevent Idiocracy from becoming a documentary.
Email complaints/requests about copyright infringement to clayton @ claytoncramer.com. Reminder: the last copyright troll that bothered me went bankrupt.
Thursday, May 5, 2022
End Mill Without Flat Spot
I bought an 1/8" carbide tipped end mill recently for a project that became unneeded. I bought an 1/8th" shank end mill holder from Sherline. When I prepared to install it, I discovered that there was no flat onto which the set screw locks. The holder had two setscrews so I was able to get an adequate grab to use it for cutting acetal. It just seemed odd. Have you ever seen an end mill without a flat?
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment