Conservative. Idaho. Software engineer. Historian. Trying to prevent Idiocracy from becoming a documentary.
Email complaints/requests about copyright infringement to clayton @ claytoncramer.com. Reminder: the last copyright troll that bothered me went bankrupt.
Saturday, August 15, 2015
Learning
I put a 1/2" thick 3.2 wide piece of 6061 aluminum and ran the side milling operation. This is wider than what I was planning for production. The left side came okay, but showed mwe I needed to use the 1/8" mill to get close to a square corner. On the other side, it wasn't on the edge and plunge milling justy vibrated everything badly. That's why I am learning on this piece of scrap!
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment