And a controller with six pins DC+, DC-, PUL, DIR, EN, GND.
From reading the manual and doing some guessing Ibelieve that the four pin plug to the stepper motor goes on the pins not labeled DC+ and DC-. Some little 2 plug probably goes on the DC pins, powering the controller and through it, the stepper motor. Wait a minute, the controller comes with a six conductor cable that goes onto the pins without using a hammer.
Does anyone know for sure? Do I just feed power into the two cables reserved for DC? The stated range is 5-30VDC. I am guessing this is passed through to the stepper motor.
No comments:
Post a Comment