tag:blogger.com,1999:blog-2807403883562053852.post8371321614018760352..comments2024-03-27T08:40:31.785-06:00Comments on Clayton Cramer.: STL FilesClayton Cramerhttp://www.blogger.com/profile/03258083387204776812noreply@blogger.comBlogger2125tag:blogger.com,1999:blog-2807403883562053852.post-87313099345549787112015-02-02T07:23:00.958-07:002015-02-02T07:23:00.958-07:00If you are primarily doing 3D work, perhaps Sketch...If you are primarily doing 3D work, perhaps Sketchup might work. I've been playing with it for wookworking purposes. I think you would need a plugin to get the STL output.rclarkhttps://www.blogger.com/profile/17821361886811348282noreply@blogger.comtag:blogger.com,1999:blog-2807403883562053852.post-67109696823705194342015-02-01T08:59:31.621-07:002015-02-01T08:59:31.621-07:00I can't recommend a specific program, but if y...I can't recommend a specific program, but if you check out the forum on cnczone.com, they can probably point you at freeware.Mauserhttps://www.blogger.com/profile/11732614352398473302noreply@blogger.com